1. The tensile strength of steel fiber is required to be not less than 380MPa;
2. The anti-bending and dismantling properties of steel fibers should be able to withstand continuous bending and dismantling of steel rods with a diameter of 3mm at 90°, and no less than 10 pieces should be inspected in each batch;
3. The content of impurities, the surface of the steel fiber shall not have oil stains, and shall not be plated with harmful substances or impurities that affect the bonding between the steel fiber and the concrete;
4. The length deviation of the steel fiber should not exceed 10% of the standard length, and at least 10 pieces are randomly checked in each batch;
5. The qualified rate of the diameter or equivalent diameter of the steel fiber shall not be lower than 90%. The weight method can be used for inspection. 100 pieces of each batch are sampled, weighed with a balance, and the length is measured with a caliper. The equivalent average value required to meet the requirements .
Inspection of raw materials:
The quality control standards of the above-mentioned raw materials must be met, and the inspection shall be carried out in accordance with the requirements of highway engineering construction technical specifications.
Inspection of steel fiber reinforced concrete:
The workability, slump and water-cement ratio of steel fiber reinforced concrete should be mainly tested. At the same time, the distribution of steel fibers in the concrete must be visually inspected on site. If steel fiber agglomeration is found, the mixing time should be extended.








